Its F1 Outdoor security camera operates using 2.4 GHz WiFi and is powered by a rechargeable 10000mAh internal battery that lasts 6-8 months after fully recharging. (Tips for fully charging the camera when you use it in the first instance). It can be used outdoors and indoors with minimal mounting installations and a simple app setup. It can also be used with solar panels (not included) to increase the working duration.
The Wireless smart camera is compatible with batteries and an AC-powered supply.
Download and install the App
This wireless camera is compatible with Android as well as ios apps. For your best experience, please scan the QR code on on the instruction paper to download and install the App, and follow the instruction to complete the user registration.
Connect the device
Log in to the App, connect to WiFi and then connect the device following the instructions (please keep the device near the router while configuring).
Install the camera
It is possible to place the camera on shelves or other surfaces and also on a wall to utilize it.
Find a suitable spot to install your camera. Place your camera at a location in which the view is not blocked. Also, ensure that it’s within the WiFi network’s coverage.
Install the bracket
The 3M glue fixing
Please remove the protective film from one end of the 3M adhesive and stick it to the area on the mounting bracket. Then, remove the protective layer on the other side, and anchor the bracket to the correct position for installation. (The surface to be installed should be smooth, clean, and dry. It’s not recommended for uneven leather, wood, or stucco surfaces. Press, then hold down the brace to the mounting position for three minutes. to achieve the highest performance in gluing performance)
Use the drill tool to make holes in the wall per the distance between the holes from the wall base. You should mark holes in the wall using a pencil before drilling. Install the expansion nut in the holes in the wall and then attach the bracket and the expansion nuts with screws for fixing.
Adjust the angle
The camera should be attached to the bracket and then alter the surveillance angle.
Network configuration and power on/off
- Press the power button for two seconds to turn on or off the device.
- Double-click on the power button to enter your network’s configuration mode after the sound of a prompt.
If you connect to the camera for the first time, use mobile App to connect the camera for the first time. App and follow the instructions to set up the camera’s network.
Charge the camera
The mobile App can remind you to recharge your camera whenever the battery is running low. Make sure to use your Micro USB cable to plug into the 5V/1.5A adapter for charging the camera. When charging, the camera’s indicator light is solid yellow. Then, after the camera has been fully charged, the indicator light changes to a solid green; it takes about eight hours to recharge the camera fully.
Be aware that if the battery is low, it will flash rapidly, with the voice calling “low battery, shutting down.” If the charger isn’t connected to the camera, it will turn off.